> Ford Expedition
> 2001 Ford Expedition Blend Door Actuator
2001 Ford Expedition Blend Door Actuator
Open the radiator cap on a cold engine and check the level. Otomatik oynat Otomatik oynatma etkinleştirildiğinde, önerilen bir video otomatik olarak oynatılır. Please reply to me thank you. Good luck. navigate here
I have changed out the BOO switch and the brake shift interlock but I still blows immediately or sometimes it works for a while but in the morning it is blown. Oturum aç 111 20 Bu videoyu beğenmediniz mi? Mark helpful 5,855 Report joef answered 3 years ago Haha yeah, I agree -- Ford cheaps out allot. It was located basically behind the glove box.
2001 Ford Expedition Blend Door Actuator
Problem: Have very little heat coming from front or rear. donnie wayne Dayton, OH #6 Friday Oct 28 I just fixed this on my truck today the a/c compressor was running when i was using heat and that made my heat Can someone help? 0 · Share on Facebook monticellorob Posts: 8 December 2007 I have a very similar problem. What is the problem?
it could be low or have air in the system. TBASCOCAT 28.061 görüntüleme 3:59 1998 F150 blend door replacement - Süre: 12:05. It worked fine. 2000 Ford Expedition Heater Not Working ChrisFix 1.256.605 görüntüleme 10:56 Ford Expedition F150 blend door stuck hot - Süre: 6:01.
HEATER DOESN'T BLOW HOT. Thanks for your comment! Bu tercihi aşağıdan değiştirebilirsiniz. Mark helpful 4,375 Report oldtimer37 answered 7 months ago Are you talking blowing hot out of floor vents or dash vents?
The switch that controls where the air will blow doesn't seem to be working properly, because I only get air flow at the window ( like defrost) and off. 1999 Ford Expedition No Heat In Front I don't think that expeditions have bleeder valves for the cooling system, so you should probably just remove the radiator cap, let the engine run, and fill the radiator at the Notify me when there are new discussions. I have also had thermostats stick closed on other cars and trucks but usually the car will over heat when that happens.
Blend Door Actuator Ford Expedition
Comments made yesterday: 30,333 • Total comments across all topics: 276,199,009 Copyright © 2016 Topix LLC • Flag inappropriate postPost has been flagged for review • Send feedback • Cancel Change A blend door will move in order to let air blow by the heater core (for heat) and the evaporator core (for a/c). 2001 Ford Expedition Blend Door Actuator First tell us what Make you're interested in. Ford Expedition Heater Blowing Cold Air The blend door actuator is in the full closed position which it would be, I think, for maximum heat.
But the only way to get to it is to remove the entire dash ("instrument panel"). check over here It is a cheap part. I had this happen to my aerostar van. It is something else. 2000 Ford Expedition Heater Control Valve Location
- The door is on a vertical axis(like your front door) and can swing back and forth at random or wedge in a set position.
- There's a world of better ideas, comin' from ford..doncha know?
- You should be able to feel the two heater hoses from a cold start and feel the hoses warm up at about the same rate and get uncomfortably hot.
- Just my 2 cents Mark helpful Your Answer Add photo Photo (optional) Related Questions I have a 2003 ford expedition my heater is blowing out cold air then it will blow
- Shawn and 3 other Ford Specialists are ready to help you Ask your own question now Share this conversation Related Ford Questions Question Date Submitted Been driving all day.
- Ford did do this on the later model Explorers, but not the Expedition.
Fords do cheap out on links! Düşüncelerinizi paylaşmak için oturum açın. You can only upload videos smaller than 600MB. his comment is here First tell us what Make you're interested in.
even when I start the truck in the am I let it run for like 20 min & still no heat!! 1999 Ford Expedition Heater Problems Could it be the heat control valve? Any ideas on what would be causing this?
Texster Allen 57.524 görüntüleme 7:31 2003-2006 Ford Expedition Front Temperature Blend Door Actuator Clicking Repair - Süre: 21:28.
Year Oops! but no heat. My front heater core is clear--we disconnected the hoses and ran water through it. 2001 Ford Expedition No Heat Evertyping else is fine.
This door directs the air flow through the heater core and regulates the temperature of the air flow. Thanks, ken_green 2009-12-19 23:22:58 UTC #2 I see none. at that point add more coolant until it wont take anymore, then put the cap back on. weblink However, the outlet hose never warms up.
I pushed water threw the system so the tubes are clear. If you are getting lukewarm air with the fan on low and when you turn the temprature control to cold and the air turns colder, it is not the door. Yükleniyor... Çalışıyor... Learn more You're viewing YouTube in Turkish.
My front heater core is clear, we disconnected the hoses and ran water though it with no problem.